Effective Ways to Use Your Guns for Shooting Deer
Mitch Johnson
There are some points that a hunter needs to know while he
strikes the deer. How he has to shot the deer is very important
to make sure the accuracy of the bullet hit. In this article you
will find some guidance on how to shoot the object.
Any tilting of the gun will nullify the effectiveness of the
sights as a means of determining the point of impact of a bullet.
To illustrate, place the gun on its side, shoot it with the
sights lined on the target and observe where the bullet hits.
This is an extreme position which the hunter would never assume,
but modifications of this position will cause misses.
Fortunately, guns are so designed and balanced that they assume
the proper vertical position provided they are held in a normal
manner by a shooter using a natural shooting stance.
The hitting of a horizontal target is a different matter and
depends on the shooter's ability to judge distances and his
knowledge of the trajectory of the bullet which he is using. The
most pleasant way I know of to observe the path which a missile
takes when moving through the air is to watch a ball game. A
baseball is far from a perfect projectile and the way it is
presented to the batter is designed to prevent him from
controlling his hit; but whenever the ball is thrown or hit, it
must travel a path that is governed by the physical law that
determines the course of all projectiles.
A line drive is the nearest thing in a ball game to a rifle
bullet that can be observed with any degree of accuracy. Suppose
that the batter, using all of his power, sends the ball into
center field. If the ball passes two feet over the pitcher's
head, it will be about four feet over second base and will hit
the ground well back in center field. The next time at bat, the
same man using the same power sends the ball in the same
direction, but this time it passes four feet over the pitcher and
reaches its highest point some distance in back of the second
baseman. Such a hit ball would probably reach the center field
fence. With the same power, added elevation results in more
distance up to a certain point. Too much elevation results in
less horizontal distance unless more power can be added. Notice
that in a line drive, the ball travels upward to its highest
point and then descends until it reaches the ground. Notice that
the rate of ascent decreases as the ball nears its highest point
of elevation and that the rate of descent increases as it nears
the ground. This is caused by the falling off of the energy
imparted to the ball by the bat. The speed, or velocity, of the
ball decreases with distance in a like manner, but such a drop in
speed is not as easily seen. There is nothing constant in the
path of a missile, be it baseball or bullet.
To return to the problem of hitting a horizontal target, new guns
are fitted with sights that are factory tested to place a certain
bullet, propelled by a certain amount of a certain powder, into a
spot at a certain distance from the gun. This may seem
complicated, but most cartridges are standard and most guns are
sighted for these standard loads. Many guns are sighted for one
hundred yards, but some of those made in the higher velocity are
set for greater distances, and a few of the older low-velocity
weapons are set for less than this distance. If the shooter
doesn't know the setting of the sights on his gun, it is a simple
matter for him to erect a target, measure off one hundred yards
and determine where his bullets hit at that distance. It is best
to use a bench rest or a prone position unless the shooter is an
expert at offhand shooting.
The hitting of a horizontal target is a different matter and
depends on the shooter's ability to judge distances and his
knowledge of the trajectory of the bullet which he is using. New
guns are fitted with sights that are factory tested to place a
certain bullet, propelled by a certain amount of a certain
powder, into a spot at a certain distance from the gun.
Mitch Johnson is a regular writer for http://www.kids-games-n-
crafts.com/. His articles have also appeared on
http://www.guidestocrafts.info/and
http://www.guidetocrafts.info/
Find More Related Information
See Also:
Index of All Hunting & Fishing Articles
Index of All Sports Articles
